diagbox vm 9.129 problem
Publié : jeu. août 04, 2022 5:24 pm
[font][font]Hello, sorry for not french but i have a problem with new diagbox 9.129 on vm.
Interface is connected, connection checker found my interface and it's with C on the end. when i launch diagbox everything is ok until i choose car, then it says connect vci, want vin and it doesn't see any module. In my laptop i have only usb 3.1, in vmware with usb is everything ok i think. Any ideas? I would try older diagbox, but i have peugeot 508 2020 and i need 2020+ cars :/[/font][/font]
Interface is connected, connection checker found my interface and it's with C on the end. when i launch diagbox everything is ok until i choose car, then it says connect vci, want vin and it doesn't see any module. In my laptop i have only usb 3.1, in vmware with usb is everything ok i think. Any ideas? I would try older diagbox, but i have peugeot 508 2020 and i need 2020+ cars :/[/font][/font]