Forum Entraide Diagnostic Peugeot - Citroen - DS - Opel

I updated latest firmware for single board to unit with two boards by mistake.

Now:
- VCI has RED LEDs on when connected to PC.
- VCI is not recognized or found by Autocom (on any port).

When trying to flash back to original firmware (replacing files in folder firmware back to ori version) pressing
on menu:

SETTINGS -> HARDWARE SETUP -> UPDATE:

VCI starts quickly blinking LEDS in red color only, and after some time blinking stops and Autocom reports this in red letters:

POSSIBLE PROBLEM
1: PC-Cable not connected to PC (but it is connected!)
2: Power cable not connected to tester (but it is connected to 12,7 Volts!)
3: selected COM-port not available (COM5 (VCP) selected autocom had it stored as default)

I hope I don't need to buy new tool due my stupidity.
Please help!


 

FIXED.

There is STMFlashLoader Demo2.8 on ST site (after registering with valid e-mail).

One need to connect two pins on MCU (138 and 108) using wire to be able to write ROM file using above tool.

When done disconnect wire and all is OK.
VCI works like new.

Topic can be closed.